Windows 2008 vpn idle timeout

You need to be careful while setting this because it should first be checked by the device vendor before making any changes. This may cause issues with the VPN tunnel if the traffic is not there for sometime. I'd like to control timeout on the server side Sign in. United States English. Ask a question.

Quick access. Search related threads. You're exactly right. The difference between Idle and Session is network activity. If there's software running on the client that's using the network lots of things could be sending traffic over the link , the Idle timeout will not kick in.

The session timeout will put a hard limit on VPN tunnels and cut the session whether it's in use or not. If you're curious what could be using network traffic on the client PC, you'll need to view it in a network monitor.

There's one for free from technet here:. It only takes a minute to sign up. Connect and share knowledge within a single location that is structured and easy to search. Basically, I want Windows to be smart enough to route traffic to "my. Is that too much to ask? It seems that traffic targetting "my.

The only benefit to that is the firewall can be configured so that file-sharing traffic can originate only from that IP address. With both VPNs established and both set to NOT use the default gateway on the VPN, and both VPNs showing those two independent IP addresses in their connection status, Explorer gets confused, cannot connect to the 2nd one, and then if I open a new window and try to go to the 2nd address, it seems to equate it with the first one and from then on both addresses and access the same folder on one server over the first VPN.

It makes no sense. Since that would pose issues for SSL certificates that show which IP addresses are valid, one would really need a VPN-aware network driver capable of automatically and transparently tunneling data from applications over the VPN tunnel.

It could be done, but I don't know if such intelligent network drivers exist. As for the issue of duplicate Server IPv4 addresses being assigned to different VPN servers in a Windows 7 client, this appears to be by design. This static pool will determine the Server IPv4 address on the client. Here I've set my second server to use My user account on each VPN server is assigned a static IP address in the Dial-In tab of the user properties under computer management.

Now, on the client, I can connect to file shares over the internet through this VPN which requires no 3rd party software at all. I simply map a network drive to each of the server's VPN addresses e. A side of effect of not being able to use the FQDN for the file sharing path is that windows may not keep the connection alive and will assume that it can be reestablished quickly as a local address, when in reality it will idle out after a minute and then take 30 seconds to reestablish a connection to the shared folder.

This can be resolved by setting a higher idle timeout in the registry. Sometimes a ping packet was lost, and sometimes not even a single ping packet was lost. The default timer is set to 30 minutes. Simply put, to be able to select a preferred physical interface for the source of the VPN traffic, or to order the preferred physical interfaces in case there are more of them. This certificate can be stored on the local machine within the User Certificates Store, or on a smart-card providing dual-factor authentication.

A certificate is also configured on the server NPS server. As with this current beta version of Windows 7, there are a few things that might confuse some folks.

Since this is a new technology, an Oakley. I have found that IKEv2 info gets stored with the ikeext. Still, I was able to find some useful info about IKEv2 negotiations from the ikeext.